ATCS Controller

SM-23

In house software and hardware development capability to implement any protocol for communication.

  • Master Slave Controllers For Data cable / wireless Communication
  • Compatible for GPS, GSM, VAS, BD, BRTS Ext.
  • Programmer 103key
  • ATCS Enable
  • Memory SREPROM
  • Display 20 X 4 LCD
  • Aspect Out Put 64
  • Synchronization RS 485 bus and Cable less synchronization using GPS.
  • Power ON checks for software & data validity
  • BRTS BUS Dictator In Out Facility
  • Communication Pots Rx232,RX485
  • One master can drive 32 slaves up to 2 km. Distance can be increased with use of repeater distance and selectable baud rates.
  • Our own protocol data frame of up to 32 bytes including start end and checksum fields.
  • Networking with Any other manufactures controller is possible very easily on receipt of protocol details.
  • The “Down” data frame ( master to slave ) includes the data fields such as junction offset time clock and lamp heads data instructions, blinker or signal switch off commands etc.
  • The “Up” data frame (slave to master) includes Bus Detector data ,vas data ,Solar Charging low bat and manual request by Policeman.
  • The master can also communicate to central computer via modem / Networking telephone lines to work under UTC or ATCS Vehicle Detection.
  • Fully compatible with any type of vehicle detector such as magnetic loop, infra-red, microwave or rubber tube. Only with connection of sensor interface card required.